Extreme Networks ExtremeWare XOS 11.3, Руководство пользователя

Страница: 614 / 698

Troubleshooting
ExtremeWare XOS 11.3 Concepts Guide
614
Switch does not power up:
All products manufactured by Extreme Networks use digital power supplies with surge protection. In
the event of a power surge, the protection circuits shut down the power supply.
To reset the power, unplug the switch for 1 minute, plug it back in, and attempt to power-up the switch.
If this does not work, try using a different power source (different power strip/outlet) and power cord.
Using the Command Line Interface
This section describes helpful information for using and understanding the command line interface
(CLI). This section contains the following topics:
●
General Tips and Recommendations on page 614
●
MSM Prompt—Modular Switches Only on page 616
●
Command Prompt on page 616
●
Port Configuration on page 617
●
VLANs on page 618
●
STP on page 618
●
ESRP on page 619
●
VRRP on page 620
General Tips and Recommendations
The initial welcome prompt does not display:
Check that:
●
Your terminal or terminal emulator is correctly configured
●
Your terminal or terminal emulator has the correct settings:
■
9600 baud
■
8 data bits
■
1 stop bit
■
no parity
■
XON/OFF flow control enabled
For console port access, you may need to press [Return] several times before the welcome prompt
appears.
The SNMP Network Manager cannot access the device:
Check that:
●
The Simple Network Management Protocol (SNMP) access is enabled for the system.
●
The device IP address, subnet mask, and default router are correctly configured, and that the device
has been reset.
●
The device IP address is correctly recorded by the SNMP Network Manager (refer to the user
documentation for the Network Manager).