Extreme Networks ExtremeWare XOS 11.3, Руководство пользователя

Страница: 439 / 698

Rapid Spanning Tree Protocol
ExtremeWare XOS 11.3 Concepts Guide
439
The protocol migration timer is neither user-configurable nor derived; it has a set value of 3 seconds.
The timer starts when a port transitions from STP (802.1D) mode to RSTP (802.1w) mode and vice-
versa. This timer must expire before further mode transitions can occur.
RSTP Operation
In an RSTP environment, a point-to-point link LAN segment has two bridges. A switch that considers
itself the unique, designated bridge for the attached LAN segment sends a “propose” message to the
other bridge to request a confirmation of its role. The other bridge on that LAN segment replies with an
“agree” message if it agrees with the proposal. The receiving bridge immediately moves its designated
port into the forwarding state.
Before a bridge replies with an “agree” message, it reverts all of its designated ports into the blocking
state. This introduces a temporary partition into the network. The bridge then sends another “propose”
message on all of its designated ports for further confirmation. Because all of the connections are
Forward delay A port moving from the blocking state to the forwarding state uses the forward delay
timer to transition through the listening and learning states. In RSTP, this timer
complements the rapid configuration behavior. If none of the rapid rules are in
effect, the port uses legacy STP rules to move to the forwarding state. The default
is 15 seconds. The range is 4 to 30 seconds.
Table 62: Derived timers
Timer Description
TCN The root port uses the topology change notification (TCN) timer when it detects a
change in the network topology. The TCN timer stops when the topology change
timer expires or upon receipt of a topology change acknowledgement. The default
value is the same as the value for the bridge hello timer.
Topology change The topology change timer determines the total time it takes the forwarding ports to
send configuration BPDUs. The default value for the topology change timer depends
upon the mode of the port:
• 802.1D mode—The sum of the forward delay timer value (default value is 15
seconds; range of 4 to 30 seconds) and the maximum age timer value (default
value is 20 seconds; range of 6 to 40 seconds).
• 802.1w mode—Double the hello timer value (default value is 4 seconds)
Message age A port uses the message age timer to time out receiving BPDUs. When a port
receives a superior or equal BPDU, the timer restarts. When the timer expires, the
port becomes a designated port and a configuration update occurs. If the bridge
operates in 1w mode and receives an inferior BPDU, the timer expires early. The
default value is the same as the STPD bridge max age parameter.
Hold A port uses the hold timer to restrict the rate that successive BPDUs can be sent.
The default value is the same as the value for the bridge hello timer.
Recent backup The timer starts when a port leaves the backup role. When this timer is running, the
port cannot become a root port. The default value is double the hello time
(4 seconds).
Recent root The timer starts when a port leaves the root port role. When this timer is running,
another port cannot become a root port unless the associated port is put into the
blocking state. The default value is the same as the forward delay time.
Table 61: User-configurable timers (Continued)
Timer Description