Extreme Networks ExtremeWare XOS 11.3, Руководство пользователя

Страница: 430 / 698

Spanning Tree Protocol
ExtremeWare XOS 11.3 Concepts Guide
430
2 If the MSMs are not synchronized, replicate all saved images and configuration from the primary to
the backup using the
synchronize
command.
3 Initiate failover using the
run msm-failover
command.
For more detailed information about verifying the status of the MSMs and system redundancy, see
“Understanding System Redundancy with Dual MSMs Installed—Modular Switches Only” on page 70 .
For more information about hitless failover, see “Understanding Hitless Failover Support—Modular
Switches Only” on page 74 .
STP Configurations
When you assign VLANs to an STPD, pay careful attention to the STP configuration and its effect on
the forwarding of VLAN traffic.
This section describes three types of STP configurations:
●
Basic STP
●
Multiple STPDs on a single port (which uses EMISTP)
●
A VLAN that spans multiple STPDs
Basic STP Configuration
This section describes a basic, 802.1D STP configuration. Figure 32 illustrates a network that uses VLAN
tagging for trunk connections. The following four VLANs have been defined:
●
Sales is defined on switch A, switch B, and switch M.
●
Personnel is defined on switch A, switch B, and switch M.
●
Manufacturing is defined on switch Y, switch Z, and switch M
●
Engineering is defined on switch Y, switch Z, and switch M.
●
Marketing is defined on all switches (switch A, switch B, switch Y, switch Z, and switch M).
Two STPDs are defined:
●
STPD1 contains VLANs Sales and Personnel.
●
STPD2 contains VLANs Manufacturing and Engineering.
The carrier and protected VLANs are also defined:
●
Sales is the carrier VLAN on STPD1 .
●
Personnel is a protected VLAN on STPD1 .
●
Manufacturing is a protected VLAN on STPD2 .
●
Engineering is the carrier VLAN on STPD2 .
●
Marketing is a member of both STPD1 and STPD2 and is a protected VLAN.