Extreme Networks Altitude 3500 Series, Руководство по продукции

Страница: 47 / 594

Altitude 3500 Series Access Point Product Reference Guide
47
●
Decal for badge
●
Safety wire (strongly recommended)
●
Security cable (optional)
To install the Altitude 3510 above a ceiling:
1 If possible, remove the adjacent ceiling tile from its frame and place it aside.
2 Install a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in diameter, in the ceiling space.
3 If required, install and attach a security cable to the Altitude 3510’s lock port.
4 Mark a point on the finished side of the tile where the light pipe is to be located.
5 Create a light pipe path hole in the target position on the ceiling tile.
6 Use a drill to make a hole in the tile the approximate size of the Altitude 3510 LED light pipe.
CAUTION
Extreme Networks recommends care be taken not to damage the finished surface of the ceiling tile
when creating the light pipe hole and installing the light pipe.
7 Remove the light pipe’s rubber stopper before installing the light pipe.
8 Connect the light pipe to the bottom of the Altitude 3510. Align the tabs and rotate approximately 90
degrees. Do not over tighten.
9 Snap the clips of the light pipe into the bottom of the Altitude 3510.
10 Fit the light pipe into hole in the tile from its unfinished side.
11 Place the decal on the back of the badge and slide the badge onto the light pipe from the finished
side of the tile.
12 Attach the radio antennas to their correct connectors.
CAUTION
Both the Dual and Single Radio model Altitude 3510s use RSMA type antenna connectors. On the Dual
Radio Altitude 3510, a single dot on the antenna connector indicates the primary antenna for both Radio 1 (2.4
GHz) and Radio 2 (5 GHz). Two dots designate the secondary antenna for both Radio 1 and Radio 2. On Single
Light Pipe
Decal
Badge
Ceiling Tile