Extreme Networks Altitude 3500 Series, Руководство по продукции

Страница: 43 / 594

Altitude 3500 Series Access Point Product Reference Guide
43
c Connect the power supply line cord to the power adapter.
d Attach the power adapter cable into the power connector on the Altitude 3510.
e Plug the power adapter into an outlet.
5 Verify the behavior of the Altitude 3510 LEDs. For more information, see “Altitude 3510 LED
Indicators” on page 48 .
6 Return the Altitude 3510 to an upright position and place it in the location you wish it to operate.
Ensure the Altitude 3510 is sitting evenly on all four rubber feet.
The Altitude 3510 is ready to configure. For information on an Altitude 3510 default configuration,
see
“Getting Started” on page 55 . For specific details on Altitude 3510 system configurations, see
“System Configuration” on page 67 .
Wall Mounted Installations
Wall mounting requires hanging the Altitude 3510 along its width (or length) using the pair of slots on
the bottom of the unit and using the Altitude 3510 itself as a mounting template for the screws. The
Altitude 3510 can be mounted onto any plaster or wood wall surface.
The mounting hardware and tools (customer provided) required to install the Altitude 3510 on a wall
consists of:
●
Two Phillips pan head self-tapping screws (ANSI Standard) #6-18 X 0.875in. Type A or AB Self-
Tapping screw, or (ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D Self-Tapping screw
●
Two wall anchors
●
Security cable (optional)
To mount the Altitude 3510 on a wall:
1 Orient the Altitude 3510 on the wall by its width or length.
2 Using the arrows on one edge of the case as guides, move the edge to the midline of the mounting
area and mark points on the midline for the screws.
3 At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall mounting
screw and stop when there is 1mm between the screw head and the wall.
If pre-drilling a hole, the recommended hole size is 2.8mm (0.11in.) if the screws are going directly
into the wall and 6mm (0.23in.) if wall anchors are being used.
4 If required, install and attach a security cable to the Altitude 3510 lock port.
5 Place the large corner of each of the mount slots over the screw heads.
6 Slide the Altitude 3510 down along the mounting surface to hang the mount slots on the screw
heads.
7 Attach the radio antennas to their correct connectors.
CAUTION
Both the Dual and Single Radio model Altitude 3510s use RSMA type antenna connectors. On the Dual
Radio Altitude 3510, a single dot on the antenna connector indicates the primary antenna for both Radio 1 (2.4
GHz) and Radio 2 (5 GHz). Two dots designate the secondary antenna for both Radio 1 and Radio 2. On Single
Radio models, a single dot on the antenna connector indicates the primary antenna for Radio 1, and two dots
designate the secondary antenna for Radio 1.
8 Cable the Altitude 3510 using an approved line cord and power supply.