Extreme Flight 110" YAK-54 V2, Инструкция по сборке

Страница: 17 / 45

Figure 10 wheel collars tailwheel wire tailwheel
3mm bolts/washers ball link tailwheel bracket tiller bolt housing/nut
Begin assembly of the tailwheel by taking the bolt housing/nylon insert nut and
installing the bolt into the tailwheel bracket and the nut. The nut goes onto the
bottom, tighten use blue thread lock (which I will not abbreviate to BTL). Now put
one wheel collar onto the tailwheel wire, then the tailwheel and align the wheel so
it is centered and then tighten the wheel collar and then put the other wheel collar
on the other side of the wheel, use BTL. Now slide the last wheel collar over the
top of the wire but do not tighten, then slide the wire up thru the bolt housing and
install the tiller onto the tailwheel wire and tighten, use BTL. Now compress the
tiller to the top of the bolt housing and slide the wheel collar up to the bottom of
the bolt housing/nylon insert nut and tighten, use BTL.
8. Measure from the rudder hinge line back 4”/102mm and drill a 1/8”/3mm hole
in the bottom of the rudder. Now epoxy the ball link into that hole, be sure to scuff
the ball link portion that will be glued. Now slide the tiller thru the ball link
and
using the 3mm bolts/washers tighten the bracket to the bottom of the fuselage.
17