Extreme Flight 110" YAK-54 V2, Инструкция по сборке

Страница: 13 / 45

Remove the covering to expose ONLY the slots. Now take the control horns and
trial fit them thru the base plate and then into the slots. Now use blue tape or other
method to determine how much covering to remove from under the base plate to
attain a base plate to wood joint. I typically leave 1/16” or 2mm of covering that
will stay under the outer edges of the base plate. Once you are happy with this take
the base plate and horns back out and scuff the lower section of the horn that will
insert into the slot and the back side of the base plate, this will provide better
adhesion. Now drop 2-4 drops of 30 minute epoxy in the slots and thoroughly coat
the portion of the control horn that will be inserted in the slot and install the base
plate and control horns.
TIP: install the ball link with the 3mm bolt while these control horns dry, this will
keep them properly aligned.
3. The horizontal stabilizers/elevator control horns are installed the exact same
way. Now is a good time to install those also.
13