Extreme Flight 110" YAK-54 V2, Инструкция по сборке

Страница: 15 / 45

Figure 8.
Finish the remaining elevator and aileron servo pushrod installations, this will
complete the wing/aileron and horizontal/elevator assemblies.
6. If you did not install the hinges into the vertical stabilizer in step 1, glue them in
now and then mate the rudder to the vertical using the same methods as the
wing/aileron. Do not install the control horns unless you are sure if you will run a
pull pull or direct drive system. These control horns are located in different places,
consult step 18 if you are sure which rudder setup you will use.(Do this only if you
are very experienced and understand the process.)
7. We will install the gear and tailwheel assembly next. It really does not matter
which you do first, for me I did the tailwheel assembly first as I felt it is easier to
15