Extreme Flight 110" YAK-54 V2, Инструкция по сборке

Страница: 7 / 45

Let's begin:
1. Locate the wing panels/ailerons and horizontal stabilizers/elevators and
associatedhardware bags. We will begin by hinging all of these at one time. I
suggest you scuff/roughthe surface of the hinges, they are slick from the
manufacturing process and the glue willadhere better to a non-slick surface. Using
100-150 grit sandpaper works well to do this, be sure you don't sand the barbs off
the hinge, you just want a little scuffing on the hinge, do not sand at the pivot
point. I strongly recommend 30 minute (or slower curing) epoxy for installing
hinges. I apply 3-4 drops of glue in the hinge hole and then using a toothpick, or
similar, suave the glue around the insides of the hinge hole. Do this on just one
surface, either the wing/horizontal or aileron/elevator it does not matter which is
first. Mix only enough glue to work with one panel at a time. Before applying any
glue to the hinge itself, I highly recommend you protect the hinge pin (pivot point)
from glue. I use Vaseline, but tape will work however it is harder to remove later,
in any case apply a protectant to the center of the hinge so gluecannot penetrate
that pin, it will cause binding. Once you have the holes lathered withglue, apply a
small amount to the hinge barbs and insert into the hinge hole twirling it as you
7