Extreme Flight 110" YAK-54 V2, Инструкция по сборке

Страница: 31 / 45

Now you can glue the baffle into the front of the cowl using epoxy, welders
adhesive or similar glues. I recommend sanding that portion of the baffle plate that
will not be seen to allow better adhesion. There are two ways to hold the baffle
plate in place with pressure. One way is once you have all the adhesive applied lay
the baffle in place, then take a small balsa stick and put it thru the hole and tie a
string to it and suspend it from the baffle hole in an upright position. The weight
will help keep it in place. Secondly, and the way I did it is to set the baffle in place
with all the adhesive applied, lay the cowling on its’ front side down on a level
surface, then put a lid from a 5 gallon bucket inside the cowl with any desired
weights to hold it in place while the glue cures. See figure 26 for a completed
cowling including the openings for the engine cylinder head inlet air.
Figure 26
31