Extreme Flight 110" YAK-54 V2, Инструкция по сборке

Страница: 41 / 45

Figure 38
You may trim the excess cable, I left about 3/8”. Optionally, from the other end of
the cable I slid a piece of heat shrink over the crimp area to protect from any
fraying and to leave a clean appearance.Be sure you cross the cable as it runs thru
the fuselage to the other hookup. Now slide the heat tubing (optional), a crimp and
the rigging coupler onto the other end of the cable. Estimate the location for the
rigging coupler to be such that it will yield a taut cable.Then repeat the process for
securing the crimp/rigging coupler as above.See figure 39 for a final hookup only
leaving the heat shrink tubing to be slid over the crimp/rigging coupler and shrunk.
Figure 39
41