Exlar Tritex, Руководство по установке

Страница: 98 / 134

Tritex 1 Installation and Setup
98
09/27/12
PN: 27666 Exlar Corporation
Rev. M 952-500-6200M
Position Limit- Indicates the commanded position is outside of the position limit range. (See
Position Limits tab on the System Set-up Page).
Analog I/O
Analog Input
The Analog input Setup and Calibration is described in the Motion Control Section
Analog Output
Mapping & Scaling
The Tritex has one analog current output with a maximum range from 0 to ~22 mA (See
Installation section for detailed specifications). The output can be mapped to internal
parameters and scaled to produce the desired output over a specified range.
Analog Output page
Analog Output is the scaled value of the analog output; the value of this parameter is displayed
while online. In the example above with Position feedback selected as the output parameter and
Minimum Output position of 0.000 inches and a Maximum Output position of 5 inches, with the
Feedback position at 0.000 inches the Analog Output will be 0%, when the Feedback Position is
at 5.00 inches the Analog Output parameter will be 100%, if the actual position is 2.500 inches
the Analog Output parameter will display 50%.
Output Variable, use the Output Variable drop down to select the drive variable to be mapped
the analog output.
Output Units : The purpose of this parameter is to display proper units in the Minimum and
Maximum Output variables; it does not affect the operation of the analog output. Select the
Output units that correspond to the Output Variable selected. For example if Feedback Position
is the Output Variable choose Distance as the Output Units, if Command Velocity is the Output
Variable choose Velocity as the Output Units.