Exlar Tritex, Руководство по установке

Страница: 91 / 134

Tritex 1 Installation and Setup
91
09/27/12
PN: 27666 Exlar Corporation
Rev. M 952-500-6200M
Minimum Velocity- This should be set to the desired motor / actuator velocity in user units when
the analog input is at the Minimum value. (see Analog Input Scaling)
Maximum Velocity- This should be set to the desired motor / actuator velocity in user units when
the analog input is at the Maximum value. (see Analog Input Scaling)
Acceleration Limit - The maximum acceleration and deceleration during Analog Positioning
regardless of the analog input rate of change.
Analog Torque Control
Analog Torque Control provides current control based on the analog input value, the input is
continuously update and scaled to provide an Analog Command current, if the Analog Current
Control is active from Default, Alternate or Host Modes the drive will operate as torque / force
control. In Analog Current control velocity and position control are the responsibility of the users
control system.
Analog Torque Page
Minimum Current- This should be set to the desired motor / actuator current in Amps when the
analog input is at the Minimum value. (see Analog Input Scaling)
Maximum Current- This should be set to the desired motor / actuator Amps when the analog
input is at the Maximum value. (see Analog Input Scaling
)
Analog Input Calibration
The analog input is calibrated at the factory; if the calibration does not match values seen in the
installation the user can adjust the factory calibration see System Setup, the Analog Input tab.