Exlar Tritex, Руководство по установке

Страница: 85 / 134

Tritex 1 Installation and Setup
85
09/27/12
PN: 27666 Exlar Corporation
Rev. M 952-500-6200M
Motion Types
Home Operation
Home page
Home parameters
Home Position:
The commanded and actual position are set to this position at the completion of
a Home cycle.
Velocity Limit:
The Home move maximum velocity. This may or may not be achieved depending
on the distance before home reached and the Acceleration parameter.
Acceleration: The acceleration ramp used during a home move
Current Limit:
This sets the current limit for the Home move. If the Termination is set to Current
Limit, the Home move will end when the Actual Current is equal to or greater than this value. If
Termination is set to Sw 1-4 and the Current Limit Value is exceeded before a switch is found a
Switch is Not Found Fault will occur. (see Faults & Warning)
Note: If the Current Limit is set to create a fault if the switch is not found, do not select both
Auto Home on Enable and Auto Enable on Startup (System Setup page). If the Actuator is
against a stop in the home direction, each time the fault is attempted to be cleared another
home against the stop is executed creating another fault.