Excelsior-HENDERSON Super X 1999, Руководство пользователя

Страница: 31 / 45

1-28
6999-0006 Rev. A
Vehicle Setup
Speedometer/Odometer Function
1. During the road test, make sure the speedometer needle
moves and reacts appropriately to changes in speed.
2. Make sure either the odometer or the trip meter display
advances as you ride.
1. SPEEDOMETER 2. ODOMETER DISPLAY
Engine Oil Level
1. With the engine at normal operating temperature, mount
the motorcycle and bring it to an upright position on level
ground.
2. With the transmission in neutral, start and run the engine
at 2500 - 3000 rpm for 30 seconds. Shut the engine off while
the motorcycle is in the upright position.
3. Rest the motorcycle on the sidestand and on level
ground. Remove the oil filler cap and wipe the dipstick clean.
Reinstall the dipstick and turn the cap clockwise until it seats.
1. FILLER CAP AND
DIPSTICK
4. Remove the dipstick again and note the oil level.
5. If necessary, add or remove oil to bring the level into the
area on the dipstick above the ADD mark and below the
appropriate MAX. mark. Repeat steps 3-4 each time you
adjust the oil level.
If you need to add any oil, use only a 15W-40 API-rated SF or
SG grade mineral based oil.
WARNING
Do not operate the motorcycle with the oil level above
the appropriate MAX. mark or below the ADD mark.
Operating the engine with too much or too little oil can
cause serious engine damage or engine seizure,
resulting in the rider losing control of the motorcycle.
1. ADD MARK
2. MAX. COLD MARK 3. MAX. HOT MARK
10583
10558
10557