Excelsior-HENDERSON Super X 1999, Руководство пользователя

Страница: 10 / 45

Vehicle Setup
6999-0006 Rev. A
1-7
Charge Battery
Use a 12 volt 1 amp charger and charge the battery at the
rate shown. If a taper or trickle charger is used, charging
times will be longer.
Notice
You can quick charge the battery with a constant
current charger. Charge at a rate of 9.0 amps for
1 hour.
If the battery gets hot to the touch, stop charging immediately.
Allow the battery to cool down before resuming charging.
Allow the battery to sit 1-2 hours before measuring the
voltage. Battery voltage must be checked before putting the
battery into service.
The battery should produce a minimum of 12.8 volts after
charging. If voltage is not 12.8 volts or more, repeat the
charging cycle.
1. VOLTMETER
Remove Saddles
To gain better access to the battery wires and terminals, we
recommend removing the motorcycle saddles before
installing the battery.
1. Remove the tandem saddle screw.
2. Lift the back of the tandem saddle slightly and pull it to
the rear, out from the tandem saddle posts.
1. TANDEM SADDLE
2. TANDEM SADDLE SCREW 3. TANDEM SADDLE POSTS
4. RIDER’S SADDLE
3. Remove the rider’s saddle screws and tandem saddle
posts.
4. Lift the back of the rider’s saddle slightly and pull it to the
rear, out from the rider’s saddle post.
1. RIDER’S SADDLE
2. RIDER’S SADDLE SCREW 3. TANDEM SADDLE POST
4. RIDER’S SADDLE POST
YTX20L-BS
Battery
Type Rate
Charging
1.8 AMPS 16 HOURS
Using 1 Amp Charger
*Time of Charge
*Charging rate will vary depending on type of charger used
10524
10187
10188