Excelsior-HENDERSON Super X 1999, Руководство пользователя

Страница: 27 / 45

1-24
6999-0006 Rev. A
Vehicle Setup
Engine Stop/Run Switch
1. With the engine running, set the engine stop/run
switch to the Stop position. The engine should stop
running immediately.
2. Turn the main switch to the Off position.
1. ENGINE RUN STOP SWITCH
Road Test
During the first 500 miles of operation, critical parts require
special wear-in procedures so they seat and mate properly.
Use the following rules for operation during the road test to
ensure the engine’s long-term performance and durability.
• Vary the engine speed.
• Do not keep a steady engine speed for an extended time.
• Do not exceed 70 m.p.h. during the test ride.
• Select gears that prevent lugging a new engine.
Within these limitations, the engine can be run at speeds up
to 3000 rpm.
Protective Apparel
We respect your right to make your own choices. However,
we recommend that you wear an approved helmet, eye
protection gloves, boots, and a jacket to prevent or reduce
your chance of injury in case of a fall during the road test.
Some state laws require that you wear an approved helmet,
eye protection, or both. Eye protection reduces the chance
that your vision could be impaired by wind or by airborne
particles and objects.
The combination of your boots and pants should completely
cover your legs, ankles, and feet, protecting you from engine
and exhaust system heat.
Engine Operation
1. Start the engine (see Starting the Engine page 1-22).
2. Allow the engine to idle for about 30 seconds. To prevent
putting the engine under load before the engine oil reaches
all areas requiring lubrication, do not rev the engine or put the
transmission in gear during this period.
3. Twist and release the throttle. The engine should respond
instantaneously.
4. Check for any unusual engine vibration or noise while
running the engine at a variety of different R.P.M’s.
10579
10580
10534
10580