Excelsior-HENDERSON Super X 1999, Руководство пользователя

Страница: 26 / 45

Vehicle Setup
6999-0006 Rev. A
1-23
Electric Starter
1. Turn the main switch to the On position.
2. Set the engine stop/run switch to the Run position.
You should hear the fuel pump momentarily as it
pressurizes the fuel system.
3. With the transmission in neutral and the throttle in
the closed position, press and hold the electric starter
button for several seconds until the engine starts.
Listen to make sure the electric starter disengages
after the engine starts.
Notice
If the engine does not start within a few seconds after
pressing the starter button, release the button and wait
several seconds. Then press and hold the starter
button again. Hold the starter button for as short a time
as possible to minimize battery drain and avoid over
heating the starter. Do not hold the starter button in for
more than 10 seconds at any time.
1. ELECTRIC STARTER BUTTON
Indicator Lights - OFF
After the engine starts the check engine indicator and low oil
pressure indicator should go out.
1. CHECK ENGINE
INDICATOR
2. LOW OIL PRESSURE
INDICATOR
Engine Idle - Tachometer
1. After the engine starts, the engine should run at a high
idle speed of approximately 1,500 R.P.M.
2. After reaching normal operating temperature, the engine
should run at a normal idle speed of approximately 950
R.P.M.
3. Use the tachometer in the instrument pod to verify the
engine R.P.M., and to make sure the tachometer is
functioning correctly.
1. TACHOMETER
10577
10578