Excelsior-HENDERSON Super X 1999, Руководство пользователя

Страница: 17 / 45

1-14
6999-0006 Rev. A
Vehicle Setup
Adjust Rear Wheel Alignment
Notice
Adjusting the rear wheel alignment involves using the
Excelsior-Henderson rear wheel alignment gauge, part
no. EH-6999-0037.
1. Remove and discard the rear axle cotter pin.
2. Loosen the rear axle castle nut enough to allow the rear
axle to slide back and forth in the swing cage.
1. COTTER PIN
2. CASTLE NUT
3. ADJUSTER JAM NUT 4. REAR AXLE ADJUSTER
5. ADJUSTER COLLAR
3. Place the open end of the rear wheel alignment gauge
over either swing cage pivot bolt.
4. Loosen the pointer thumb screw and slide the pointer
along the rod until pointer tip rests in the center dimple of the
rear axle. Tighten the pointer thumb screw.
5. Move the alignment gauge to the opposite location on the
other side of the motorcycle.
6. Loosen the adjuster jam nuts.
1. ALIGNMENT GAUGE 2. POINTER
7. Turn the rear axle adjuster in or out until the dimple in the
rear axle aligns with the pointer tip. Make sure the rear axle
adjusters are seated against the adjuster collars.
8. Repeat steps 1-4 on alternate sides of the wheel until the
distance from the swing cage pivot bolt to the rear axle center
dimple is equal on both sides of the motorcycle.
9. Check the drive belt tension and adjust it if necessary
(see Check Drive Belt Tension page 1-15).
10. Tighten the adjuster jam nuts.
11. Tighten the rear axle castle nut.
Torque: 111 ft-lbs
1. ADJUSTER JAM NUT 2. CASTLE NUT
12. Recheck drive belt tension, and install a new rear axle
cotter pin.
WARNING
Do not reuse a cotter pin because it may fail, causing
the rear wheel to loosen and the rider to lose control of
the motorcycle.
1. COTTER PIN
10553
10552
10554
10555