Excelsior-HENDERSON Super X 1999, Руководство пользователя

Страница: 13 / 45

1-10
6999-0006 Rev. A
Vehicle Setup
2. Position the motorcycle on level ground in an upright
position. Raise the front wheel off the ground with an
appropriate motorcycle lift or by placing a block of wood or
steel securely under the frame.
3. With the front wheel straight, hold the lower end of the
front forks near the axle and try to move the forks forward and
backward. The forks should have no freeplay (forward and
backward movement).
4. If any freeplay is present, the steering head bearings
should be adjusted. See the motorcycle’s Service Handbook.
Fork Lock
1. Turn the handlebars fully to the left. Insert the key into the
fork lock and turn it clockwise. Remove the key and make
sure the handlebars are locked.
2. Reinsert the key and turn it counterclockwise. Remove
the key and make sure the handlebars turn freely from side to
side.
1. FORK LOCK
Install Mirrors
1. To install both right and left mirrors, insert the threaded
end of the mirror into the threaded receiver on either right or
left hydraulic fluid reservoirs.
2. Thread each mirror all the way into the receiver, then
back each mirror out until it faces the rear of the motorcycle.
3. Tighten the locking nut on the mirror shaft to lock the
mirror in place.
4. Adjust the mirrors as necessary.
1. LOCKING NUT
Throttle
Throttle Control Grip and Cables
1. Rotate the throttle control grip. It should rotate smoothly
from its rest position to its completely open position and back
again. It should return to its rest position quickly when
released.
2. Throttle freeplay — the amount of throttle control grip
movement from the rest position to the point of cable
resistance should be between 1/16” and 3/16”.
3. Adjust throttle freeplay as necessary.
10479
10497
10545
10544