Evil Mad Scientist AxiDraw MiniKit 2, Инструкция по сборке

Страница: 12 / 75

6 mm
2.3 Add pulleys to motors
1. Locate the flat face ( A ) on the shafts of the stepper motors, #13 .
2. Observe that the timing belt pulleys, part #14 , each have two set
screws ( B ). The wrench for these screws is the 2 mm Ball-end Hex
L-wrench #3 .
3. Slide a pulley onto a motor shaft, “teeth” up. You may need to
loosen the set screws to do so.
4. Position the pulley with a set screw in front of the flat face, and
with its bottom 6 mm above the uppermost part of the motor face
( C ). You can use a ruler to measure the gap or – much better – bor-
row a Black Nylon Spacer ( #22 ) from a future step and use it as a
spacer to measure the gap ( D ).
A
C
D
B
(Continues on next page)
12