Evil Mad Scientist AxiDraw MiniKit 2, Инструкция по сборке

Страница: 29 / 75

B
3.7 Front X Wheels
1. Identify parts
#37
,
#38
, and
#39
, the M4×22 But-
ton-head Screw, Roller Wheels, and M4 Nylon Locknuts.
The screws are the longest in the kit, 22 mm long, with a
hexagonal socket on the head. The M4 Locknuts have a
hexagonal outline and rounded tops.
2. Also locate the thick M4×7×3 Spacers #30 and M4×10×1
Stamped Washers
#31
which will be used in this step. (Re-
fer to §3.3, “Spacers, shims, and washers” on page 23
for more about identifying these parts.)
3. Slip one of the M4×22 screws through a wheel, and then
through one of the thick 3 mm spacers #30 . Repeat this
to make two of these stackups ( A ).
4. Slip the two stackups up through the two corner holes at
the front side of the Carriage Plate, from the bottom to-
wards the top ( B ). On the top side of the Carriage Plate,
place a 10 mm Stamped Washer #31 over each screw and
then thread on an M4 Nylon Locknut
#39
.
#37
A
#38 #39
#37
, M4×22 Screw
#31 , 10 mm Washer
#39 , Locknut
#30
, Spacer M4×7×3
#38
, Roller Wheel
Tip: There is a shim spacer inside each roller wheel. If
the screw does not easily slip through the wheel, it is
possible that the spacer is in the way. Use your 2 mm
Hex L-wrench to push the shim back into position so
that the screw fits through.
(Continues on next page)
29