Evil Mad Scientist AxiDraw MiniKit 2, Инструкция по сборке

Страница: 17 / 75

2.6 Mounting the EBB
1. Identify the EBB Driver Board #18 , and the EBB Support #19 . You
will also need the four long, black M3×16 Button-head Screws
#20
,
the White Nylon Washers #21 , the Black Nylon Spacers #22 , and the
M3 Kep Nuts #23 . The spacers are short black plastic tubes, and the
nuts are distinguished by having a built-in toothed washer.
2. Slide a white nylon washer over each screw ( A ), and then insert the
screws through the four corner holes of the EBB ( B ).
3. Holding the EBB vertically with the power jack facing sideways as
shown ( C ), slide one of the black nylon spacers over each screw.
Place a finger over each screw head as you slide its spacer on, to
prevent the screw from popping out of the hole.
#18
#21
#22
#23
#20
(Continues on next page)
A
B
C
Tip: Rest the EBB on top of the Base Rail for easy access.
Tip: If you have difficulty with this step, it may be helpful to put
a small piece of tape over the screw heads.
17