Ever SINLINE PRO 10000, Инструкция по эксплуатации

Страница: 27 / 42

Instruction manual for SINLINE PRO 10000 series power supply units
2010/08/24
www.ever.eu
27
The system must be structured in such a way as to make possible the disconnection
of the power supply unit from the mains, e.g. by the switching of integrated
overcurrent cut-outs.
NOTE! The UPS should be connected by qualified and authorised
personnel only.
NOTE! The UPS is completely disconnected from the power network
only when the power supply cord is disconnected.
It is recommended that protection circuits of the building's electric system be used as
one of the protection levels. The parameters of the building's electric system
protection circuits should be selected in accordance with the type and magnitude of
the load connected to the system. In extreme cases, different characteristics of the
building's and power supply unit's protection systems may cause the former to be
activated more rapidly.
NOTE! The user is obligated to place the following information on all
mains cut-outs installed far from the point of placement of the power
supply unit:
"BEFORE COMMENCING WORK ON THIS CIRCUIT, YOU MUST:
- DISCONNECT THE UNINTERRUPTIBLE POWER SUPPLY (UPS)
SYSTEM
- CHECK FOR ANY VOLTAGE BETWEEN ANY OF THE TERMINALS
(INCLUDING THE PE TERMINAL)
RISK OF REVERSE POWER SUPPLY"
Electrical system
The electrical system should be structured in accordance with the installation
guidelines elaborated for the power supply unit. The guidelines constitute a separate
document attached to the product.
START-UP
NOTE! If no battery module is connected to the power supply unit,
the F5 module fuse should not be installed (installation of the fuse
would lead to the appearance of a dangerous constant voltage on
the connecting strip of the battery module).