3.
CAUTION! Never pour water into the pressure cooker and immerse the power cord into
water. Always make sure the inner pot is completely dry before placing it in the pressure
cooker body.
4.
After initial cleaning, reattach the top lid of the pot, install the ring with a silicone seal and
a metal filter. When attaching the metal filter, secure it through all three retaining clips. Then
push it into place until you hear the click sound.
5.
Place the plastic condensate container on the back of the pot and connect the power cord
in the electrical outlet and then in the pressure cooker (pic. 4)
.
HOW TO OPEN PRESSURE COOKER
(pic. 2, 5, 6)
Move the valve to „
Exhaust
“ Grasp the lid firmly, press the release button
„
PVC 0.2mm
黑底银字
“ and rotate it clockwise. The mark on the lid
will be aligned on
the mark
on the pot body. Nevertheless, a slight vacuum may occur in the pot, so you
can also raise the inner stainless steel container with the lid.
HOW TO CLOSE LID OF PRESSURE COOKER
Before closing the pot, make sure that the silicone seal is correctly fitted over the entire lid
of the top lid and the metal filter is attached. Grasp the lid firmly and turn it counterclockwise
you hear a click and a beep. The mark on the lid
will be aligned on the mark
on the
pot body.
Caution: If the silicone seal ring is damaged, stop cooking!
IMPORTANT INFORMATION FOR DAILY USE
Make sure the pressure cooker is working properly before each use:
NEVER USE PRESSURE WITHOUT INNER POT!
Ensure that the inner pot is completely dry before placing it in the pot body. After inserting
the inner pot into the body of the pressure cooker, gently rotate it to ensure good contact
between the inner pot and the heater at the bottom of the pot. Check that the metal filter is
clean. You check it regularly the metal filter after every use and you should and clean it if
necessary.
The total amount of ingredients together with water must not exceed the 2/3 MAX
PRESSURE COOK (4,1 l) mark in the cooking pot. When preparing food, which increases
in volume during the cooking process, do not fi ll the cooking pot over the 1/2 (2,97 l) mark.
However the amount of food being cooked must not be less than indicated by the CUP2
(0,76 l) mark. For liquid porridge, it is recommended to use rice and water in a ratio of 1: 3,
(pic. 3)
.
CONTROL PANEL - BUTTONS
Button
Program
Temperature
(°C)
Pressure
(kPa)
Button
Program
Temperature
(°C)
Pressure
(kPa)
Soup
165
50 ~ 70
Rice
165
50 ~ 70
Mea
165
50 ~ 70
Grains
165
50 ~ 70
36
GB
/ 87
