2.
After each use, disassemble and clean the top lid, metal filter, and check the silicone
sealing ring. If the vent filter is dirty or contains dirt, clean it.
3.
Wash the parts in warm, soapy water. Do not put these parts in the dishwasher.
4.
Clean the vent pipe if it is blocked or partially blocked.
5.
Thoroughly dry all parts.
6.
Remove the removable inner pot and wash the pot in warm water with a mild detergent.
This pot is also dishwasher safe.
7.
Do not allow liquid to enter the pressure cooker body.
WARNING! Never put liquid into the pressure cooker itself or immerse it in water. Always
make sure that the device is completely dry before use.
Storage
Before storing make sure that the pressure cooker is cool. Insert accessories
D
into the
cooking pot
C
. Store the pressure cooker in a safe dry location, out of the reach of children.
Some foods may stain the accessories in a certain way. This however has no effect on
the operation of the appliance and is not cause for a claim or complaint regarding the
appliance! After some time this staining usually goes away by itself.
V. TROUBLESHOOTING
•
What does it mean when
E3
appears in the display window and the unit stops working?
The cooker has overheated. You likely operated the unit in pressure cooking mode with
insufficient or no liquid. If this occurs, unplug the unit and allow it to cool. Then remove
the cover and add liquid to the cooker. Plug the unit back in, place the cover on, and
reprogram the cooker.
•
What does it mean when
E1, E2
or
E4
, appear in the display window and the unit stops
working?
E1
: Sensor error,
E2
: Short circuit,
E4
: Low pressure sensor error. Contact an
authorized service centre
•
Sometimes when pressure cooking, I notice beads of moisture forming in the area of the
pressure release valve. I also sometimes hear what sounds like escaping steam prior
to the point in time that the timer begins to count down. Is there something I am doing
wrong? No. Both are normal and can be expected as part of pressure cooking.
•
I pressed the wrong button by accident and the cooker is not allowing me to press the
right one. What can I do? Press „Keep warm/Cancel“ button. This will enable you to start
over and press the correct button.
•
When I tried to adjust the time, it did not change. What am I doing wrong? You did not
adjust the time within the first six seconds. Press „Keep warm/Cancel“ and begin again by
choosing the desired setting and adjusting the time as needed.
•
I can see steam escaping from around the cover. Why? You forgot to put the silicone
sealing ring on the sealing plate or you forgot to install the sealing ring plate in the cooker
cover.
NOTICE: If either of these parts are not in place during cooking, the cooker will leak,
pressure will not build, and you may damage the unit.
•
I can hear steam venting from the quick pressure release valve and pressure is not
building. Why? You have the quick pressure release valve in the “
E
xhaust
” position.
42
GB
/ 87
