Hardware Mounting
We.R System
27
9.4.1
To Mount the Sensors
1.
Peel off the mounting tape’s protective covering and mount the larger
Magnetic Detector on the frame side of a door or window, see Figure 24.
2.
Peel off the mounting tape’s protective covering and mount the smaller
Magnet on the surface of the door or window, opposite the Magnetic
Detector.
3.
Both devices have a "•" mark on the front. These marks must be aligned
to each other and located at the same position and same height.
4.
If required, due to installation constraints, it is possible to mount the
Magnetic Detector on the surface of the door or window, and the Magnet
on the frame-side of a door or window. A green LED indicates that the
device elements are aligned and coupled. A red LED indicates that the
device elements are out of range or misaligned (i.e. the door is open).
Figure 24: Window/Door Sensor Mounting Diagram
Best Practice
The distance between the 2 components should be no more than 1-2 cm.
Ideal mounting locations are high up and out of reach.
For a quick test after a magnet is fully installed:
Close the door / window – a Green LED glows, indicating a correct
installation.
Open the door/ window – a red LED glows, indicating a correct installation.
For detaching the magnetic detector from the surface of the door or window
(in the event of battery replacement or any other maintenance activity), insert
a coin or a screwdriver in the hole, at the side of the device, and pry the
Magnet cover off carefully.
9.5
Mounting/Dismounting an Indoor Siren
1.
Peel off the mounting tape’s protective covering and Mount the Indoor
Siren on a wall in a suitable location that will allow the alarm to be heard
and act as a deterrent to potential intruders.
