Control Panel Hardware Setup
We.R System
7
1
Control Panel Hardware Setup
Prepare your system for activation, The Control Panel must be activated and your
system registered with the responsible party. To setup and activate the Control
Panel, do the following:
1.
Open the back cover of the Control Panel and find the barcode. The serial
number of your We.R system is the last 8- alpha-numeric characters in the
barcode. Record the serial number in
Appendix G. The serial number will
be required later in the system installation process.
2.
(Optional) Insert the SIM card, face down, as illustrated below. Refer to
the graphic representation, next to the designated SIM location, for further
assistance.
Figure 1: SIM Card Placement
3.
If the Control Panel will be using an Ethernet connection, plug the network
cable in to the network socket on the back of the Control Panel, and then
into a network socket on a wall.
If there is no internet connection available (via the Ethernet cable), the
SIM card will be used as the primary connection between your system and
an external environment.
Figure 2 Ethernet Connection
4.
Plug the power cable into the mini-USB port on the Control Panel and into
an electric socket on a wall. The LED on the front of the Control Panel
glows orange.
5.
Insert the square battery, label up, into the back of the Control Panel. The
battery lies on top of the SIM card. Verify that the battery contacts are
touching.
6.
Put the back cover of the Control Panel back, and place the Control Panel
on a flat surface and wait for the LED in front to turn from orange to green
before moving on to section
2 We.R System Registration.
The green LED indicates that the Control Panel is activated. It can take
approximately 5 minutes for the LED to turn green. If the LED does not
turn green after 5 minutes, see
Appendix A: Power Up Devices
(Peripherals).
