ESAB ET 220i AC/DC, Руководство по эксплуатации

Страница: 59 / 74

ET 220I AC/DC
Manual 0-5346 BASIC WELDING GUIDE
4-13
TIG Welding is generally regarded as a specialised process that requires operator competency. While many of the principles out-
lined in the previous Arc Welding section are applicable a comprehensive outline of the TIG Welding process is outside the scope of
this Operating Manual. For further information please refer to www.esab.com or contact ESAB.
4.04 TIG (GTAW) Welding Problems
FAULT CAUSE REMEDY
1 Excessive bead build up or
poor penetration or poor
fusion at edges of weld.
Welding current is too
low
Increase weld current and/or faulty joint
preparation.
2 Weld bead too wide and
flat or undercut at edges
of weld or excessive burn
through.
Welding current is too
high
Decrease weld current.
3 Weld bead too small or
insufficient penetration or
ripples in bead are widely
spaced apart.
Travel speed too fast Reduce travel speed.
4 Weld bead too wide or
excessive bead build up or
excessive penetration in
butt joint.
Travel speed too slow Increase travel speed.
5 Uneven leg length in fillet
joint
Wrong placement of
filler rod
Re-position filler rod.
6 Electrode melts or oxidises
when an arc is struck.
A Torch lead connected
to positive welding
terminal.
A Connect torch lead to negative welding
terminal.
B No gas flowing to
welding region.
B Check the gas lines for kinks or breaks
and gas cylinder contents.
C Torch is clogged with
dust or dirt.
C Clean torch.
D Gas hose is cut. D Replace gas hose.
E Gas passage contains
impurities.
E Disconnect gas hose from the rear of
Power Source then raise gas pressure
and blow out impurities.
F Gas regulator turned
off.
F Turn on.
G The electrode is too
small for the welding
current.
G Increase electrode diameter or reduce the
welding current.
H Power source is set for
Stick welding.
H Set Power Source to a GTAW operating
mode.