ESAB ET 220i AC/DC, Руководство по эксплуатации

Страница: 20 / 74

ET 220I AC/DC
INSTALLATION, OPERATION AND SETUP Manual 0-5346
3-8
25. Digital Ammeter / Parameter Codes
The digital amperage meter is used to display both the pre-set current and actual output current of the power source. It is also used
to display Welding Parameter Codes.
Depending on the Welding Parameter selected, the status indictor adjacent to the ammeter will illuminate to show the units of the
welding parameter.
When welding, the amperage meter will display actual welding current.
At the completion of welding, the amperage meter will hold the last recorded amperage value for a period of approximately 10 sec-
onds. The amperage meter will hold the value until; (1) any of the front panel controls are adjusted in which case the unit will revert to
preview mode, (2) welding is recommenced, in which case actual welding amperage will be displayed, or (3) a period of 10 seconds
elapses following the completion of welding in which case the unit will return to preview mode.
26. Seconds indicator light
This light will illuminate when Seconds are being shown on the Digital Ammeter Display.
27. Amps indicator light
This light will illuminate when Amps are being shown on the Digital Ammeter Display.
28. Digital Voltmeter / Parameter meter
The digital volt meter is used to display the actual output voltage of the power source. It is also used to display Welding Parameters.
Depending on the Programming Parameter selected, the status indictor adjacent to the volt meter will illuminate to show the units
of the welding parameter.
When welding, the volt meter will display actual welding voltage.
At the completion of welding, the volt meter will hold the last recorded voltage value for a period of approximately 10 seconds. The
volt meter will hold the value until; (1) any of the front panel controls are adjusted, (2) welding is recommenced, or (3) a period of 10
seconds elapses following the completion of welding.
29. Inch indicator light
This light will illuminate when "Inches (")" are being shown on the Digital Volt meter Display for electrode diameter size.
30. HOLD indicator light
This light will illuminate when the HOLD function is active on the Digital Display at the completion of welding.
31. Seconds indicator light
This light will illuminate when Seconds are being shown on the Digital Volt meter Display.
32. Volts indicator light
This light will illuminate when Volts are being shown on the Digital Volt meter Display.
33. kHz (frequency) indicator light
This light will illuminate when kHz (frequency) is being shown on the Digital Volt meter Display.
34. Hz (frequency) indicator light
This light will illuminate when Hz (frequency) is being shown on the Digital Volt meter Display.
35. % (percentage) indicator light
This light will illuminate when % (percentage) is being shown on the Digital Volt meter Display.
36. Job Number indicator light
This light will illuminate when Job Number is being shown on the Digital Volt meter Display.
37. Remote Control indicator light
This light will illuminate when the Remote Control is active.