ESAB ET 220i AC/DC, Руководство по эксплуатации

Страница: 33 / 74

ET 220I AC/DC
Manual 0-5346 INSTALLATION, OPERATION AND SETUP
3-21
Load a TipTronic Job
• Using the Welding Mode button (10) select TipTronic mode (14).
Either 2T or the 4T may be lighted as well as the TT symbol for Tip Tronic setting depending on the last saved job.
• Use the Multi Function Control (24) to select the job set number and the job number.
Set a TipTronic Job as Inactive
• Press the SAVE button (53).
The display will show the Job Number identification, the job set and job number.
• Use the Multi Function Control (24) to select the job set number and the job number.
• Press the GAS button (51). The light will toggle on and off as you press the button. Press the button so the light is off.
• The TipTronic job is now inactive. Note that the JOB LED (52) will extinguish.
• To exit this mode, press the SAVE button (53).
Set a TipTronic Job as Active
• Press the SAVE button (53).
The display will show the Job Number identification, the job set and job number.
• Use the Multi Function Control (24) to select the job set number and the job number.
• Press the GAS button (51). The light will toggle on and off as you press the button. Press the button so the light is on.
• The TipTronic job is now active. Note that the JOB LED (52) will illuminate.
• To exit this mode, press the SAVE button (53).
Copy a TipTronic Job to another Job Number
• Using the Welding Mode button (10) select TipTronic mode (14).
• Use the Multi Function Control (24) to select the “source” job set number and the job number.
In our example we are copying from Job Number 2-9.
• Press the SAVE button (53).
• Use the Multi Function Control (24) to select the “destination” job set number and the job number. In our example we are copying
to Job Number 6-7.
• Press and hold the SAVE button (54) until all LED’s illuminate briefly to indicate a Save has been completed.