ESAB ET 220i AC/DC, Руководство по эксплуатации

Страница: 34 / 74

ET 220I AC/DC
INSTALLATION, OPERATION AND SETUP Manual 0-5346
3-22
3.14 Setup for Stick (SMAW) Welding
A. Connect the Electrode Holder lead to the Electrode welding terminal (top). If in doubt, consult the electrode manufacturer.
Welding current flows from the Power Source via 50mm Dinse type terminals. It is essential, however, that the male plug is
inserted and turned securely to achieve a sound electrical connection.
B. Connect the work lead to the Worklead welding terminal (bottom). If in doubt, consult the electrode manufacturer. Welding
current flows from the power source via 50mm Dinse type terminals. It is essential, however, that the male plug is inserted
and turned securely to achieve a sound electrical connection.
C. Select Stick and electrode positive mode with the welding mode and welding type buttons (refer to Section 3.15 for further
information)
!
WARNING
Before connecting the work clamp to the work and inserting the electrode in the electrode holder make
sure the mains power supply is switched off..
!
CAUTION
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the Welding
Power Source.
!
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being fused in the
50mm Dinse type terminal.
T
4T 2T
Art # A-12848
Figure 3-11: Setup for Manual Arc Welding