ENSONIQ ASR-X PRO, Руководство пользователя

Страница: 39 / 74

Insert Effect Parameters
ENSONIQ ASR-X Pro UserÕs Guide 31
ensure precise hold time durations. If you desire a separate gate on each and every note, use the Non Lin
reverbs.
PPP
Paaaarrrraaaam
m
m meeeetttteeeerrrr
RRR
Raaaannnnggggeeee
D D
D Deeeessssccccrrrriiiippppttttiiiioooonnnn
Gate Thresh -96.0dB to 0.0dB Sets the signal level that triggers the gated reverb. When
the incoming signal reaches this value, it triggers (starts)
the gated reverb. Higher values would require a
stronger incoming signal. Set this parameter as low as
possible to work with your particular source, but not so
low as to cause false triggering.
Gate Hysteresis 0dB to 48dB Sets the lower threshold level relative to Gate Thresh
below which the Gate Hold Time begins. If the
difference between Gate Thresh and Gate Hysteresis is
lower than the level of the incoming signal, the gated
reverb will continue to retrigger. With a high decay rate,
this adds a cavernous quality to percussion instruments.
Gate Attack 50us to 10.0s Sets the attack time of the gated reverb once the
incoming signal has reached the trigger level. Generally
the attack should be short and not set longer than the
Gate Hold time.
Gate Release 50us to 10.0s Sets the amount of time after the Gate Hold time has
elapsed for the gated reverb to shut down. Generally
these times are very short.
Gate Hold 50us to 10.0s Sets the amount of time that the reverb will hold after
the retrigger and before the release. The Gate Hold time
will begin again if retriggered.
Decay 0sec to 10.0sec Sets the decay rate. In general, the decay rate is set very
high.
HF Damping 100Hz to 21.2kHz Controls the rate of attenuation of high frequencies in
the decay of the reverb. Increasing the value of this
parameter will gradually filter out increasing amounts
of high frequency energy.
Diffusion 1 0 to 100 Smears the transients, so as to diffuse and smooth the
sound. Lower values will cause impulsive sounds to
appear as a series of discrete echoes, while higher values
tend to increase the smear (smoother sounding).
Recommended setting is approximately 50.
Diffusion 2 0 to 100 This parameter, similar to and in series with Diffusion 1,
performs the same way but controls lower frequency
ranges. Recommended setting is approximately 50.
Definition 0 to 100 Controls the rate of echo density build up in the reverb
decay. If set too high, the echo density will build at a
rate that exceeds the decay rate. A general rule of
thumb: Definition should not exceed the Decay Rate. We
recommend settings between 25 and 50.
Slap Time 0ms to 108ms Controls the delay time of an internal dry stereo signal
to create a slapback. In general, the slapback is greater or
equal to the Gate Hold time to achieve a reverse effect.
Slap Level Off, -49.5dB to +12.0dB Adjusts the volume of the slapback (internal dry) signal.
ER 1 Level
ER 1 Level
ER 1 Level
ER 1 Level -99% to +99%
-99% to +99%
-99% to +99%
-99% to +99% These parameters control four early reflection levels.
Setting these levels to lower values will produce a
wetter sound. A setting of 0% turns the early reflections
off.
Output Bal Full <L to Full >R Controls the left/right stereo balance of the gated reverb
signal.