Model OUM980 with OUSAF21 Inline Sensor
Commissioning
28
5.3.5
Output Relay Set Point and Configuration
Change Output Relay Set Point
Change Relay Set Point
Enter PROCESS SET-UP sub-menu to access
OUTPUT SPANS function.
Use
to move the cursor to ALx and press
to select.
In this screen the current value for span is the FROM value. Position the
cursor as done previously and select the number for that position.
Repeat as needed for each digit position. When the new relay set point
has been entered
，
press
and confirm the sanity check to accept.
Configure Output Relays
The Alarm Setup screen allows configuration of PV, Hi/Lo/Off, and NO/NC operation.
is used to select the
parameter and
is used to change the state. Press
to continue.
Functions
Description
HIGH
Triggered if process value higher than set point.
LOW
Triggered if process value higher than set point.
Trigger Condition
OFF Relay
disabled
PV1
Process value #1
Input Mapping
PV2
Process value #2
NO Normally
open
Relay Operation Mode
NC Normally
close
Hysteresis
Set relay hysteresis
Delay
Delay trigger timer (Sec)
Table 5.2: Output Relay Configuration
