Endress+Hauser Analytik Jena multi N/C, Руководство по эксплуатации, Страница: 63 / 106

multi N/C pharma UV Operation
63
Three calibration
ranges exist A maximum of three calibration ranges can be stored for each
parameter in a method. In this case the ranges can only be replaced.
Delete the range to be replaced in the right-hand columns using the
button [D
ELETE
].
Transfer the currently determined calibration data with the button
[A
CCEPT VALUES
].
Check on the basis of the calibration ranges that a seamless linking of
several ranges has taken place.
The following generally applies:

Pressing the button [A
CCEPT VALUES
] causes an automatic allocation of the
calibration ranges by the software.

By pressing the button [D
ELETE
] you first make an initial selection which range
should be replaced.

A
SEAMLESS LINKING
means that the top end of the area of one calibration range
corresponds to the bottom end of the area of the next calibration range (see Fig.
34 table, first line)

The accepted calibration parameters are used for the calculation of all subsequent
analyses with this method.
Fig. 34 Window L
INK WITH METHOD
with three areas