Transport and storage
multi EA 5100
168
If the device is not installed immediately after delivery or not required for longer periods,
it should be stored in its original packaging. A suitable desiccant should be added to the
equipment to prevent damage from moisture.
The requirements for the climatic conditions of the storage location can be found in the
specifications.
15.4 Preparing the basic module for transport and storage
Prepare the basic module for transport as follows:
}
Switch off the basic modules via the power switch and allow the device to cool.
}
Switch off the gas supply and disconnect the power plug from the power outlet.
}
Disconnect all connection on the rear of the module.
}
Remove the combustion tube (→ "Maintenance of the multi-purpose combustion
tube"
126).
}
Remove the auto-protection valve assembly (→ "Maintenance of the auto-protection
valve assembly"
}
Remove the membrane dryer with holder from the combustion furnace (→ "Replac-
ing the membrane dryer"
134).
}
Remove the combustion furnace (→ "Removing and installing the combustion fur-
nace"
}
Pack open hose ends in protective bags and secure them with adhesive tape.
}
Close the doors of the basic module.
}
Position the top cover and secure it with adhesive tape.
}
Secure the maintenance flaps on the right device side with adhesive tape.
}
Carefully pack the combustion furnace and additional accessories in the original
packaging. Especially the glass components must be packed safely against breakage.
15.5 Preparing detection modules
CAUTION
Risk of injury
A risk of injury due to broken glass is present when handling glass parts.
¡
Handle glass parts with extreme caution.
