ENCAD NovaJet 4, Руководство пользователя

Страница: 178 / 200

J-178 Troubleshooting
User's Guide
You may be sending a raster file (HP RTL). Raster files are binary files.
Use the GO.EXE utility provided on the Utility disk sent with your
printer (GO [filename]) or use the DOS binary switch when issuing the
Copy command. The command line should be:
COPY /B [filename] LPT1.
Jagged vertical lines
Check that the ink cartridges are properly installed, then run the calibra-
tion procedure. (See "Installing Ink Cartridges" and Appendix A.)
Prime the ink cartridge to be sure that all the inkjets are firing properly.
(See "Priming for Cartridge Print Check in Chapter 2.)
Clean the ink cartridges. (See Appendix I.)
Try another cartridge.
If these suggestions fail, call ENCAD Technical Support for instructions
on cleaning the Encoder Strip and performing Deadband Calibration.
Splotchy area fill
Try using enhanced mode. If the problem persists, prime the ink cartridge
to be sure that all the inkjets are firing properly. (See "Priming for
Cartridge Print Check" in Chapter 2.)
Excessive banding in area fills
Consistent banding is a hardware problem; inconsistent banding is
generally a software problem.
Use specially coated inkjet media. ENCAD provides a full line of high
quality inkjet media. (See Appendix G.)
Change the Print Mode option to one of the Enhanced modes. Try 3 or 4-
pass enhanced. (See "Graphics Print Modes" in Chapter 5.)
Perform color calibration. (See Appendix A.)
Clean the ink cartridges. (See Appendix I.)
Set wiper function to "no wipe".