ENCAD NovaJet 4, Руководство пользователя

Страница: 169 / 200

Troubleshooting J-169
User's Guide
APPENDICES
Takeup roll doesn't stop turning (printers with power media
feed)
Check that the sensor is not blocked. There should be nothing between
the sensor and media.
Takeup roll doesn't turn when using clear media
Block takeup sensor to be sure that take-up rollers advance. Call Techni-
cal Support for instructions on applying a smaller cover over the sensor
lens.
Cut sheet media falls to the floor after the print is completed
Some media sizes are very similar to each other and the printer may
incorrectly size the sheet. To prevent this, set the Media option for the
media standard you are using (US ARCH, US ENG., etc.). (See "Select-
ing the Media Standard" in Chapter 4.)
Automatic cutter doesn’t work or tears the paper
Make sure the Cut option in the Printer Setup menu is set to ON (the
default).
Make sure the cutter is properly installed. (See "Installing the Cutter" in
Chapter 2.)
TURN POWER OFF and clean the inside of the black belt using
alcohol and a lint-free cloth. Push the carriage back and forth to access
all areas of the belt. Manually push the carriage all the way to the left to
force the cutter to drop. Turn power on.
If the cutter is worn, replace it. You should replace the cutter after every
200 plots (more or less, depending on the type of media used). (See
Appendix G for ordering information.)
Carriage jams
Check for paper jams or blockage.
Be sure the service station is lowering. If it does not lower, push it left
and down, or the cutter will not disengage.