ENCAD NovaJet 4, Руководство пользователя

Страница: 16 / 200

User's Guide
1-16 Introduction
Caring for your media
Store media in its original packaging in a cool, dry area until you are
ready to use it. The environment should be stable; i.e., no extremes of
heat and cold, and non-condensing humidity. If conditions are outside
the operating ranges recommended for the printer, allow the media to
acclimate in the operating environment for at least 48 hours before using
it.
If you remove a roll of media from the printer, be sure to store it in a
manner which keeps it clean and dust-free. Ideally, you should return it
to its original packaging for storage.
Print on the correct side! Roll media is wound with the preferred side
out. Media should feed over the top of the roll. Cut sheet media has an
ink-receptive and a non-ink-receptive side. The sheets are notched to
help you orient them correctly. To assure that you print on the correct
side, be sure that the notch is in the upper right corner when you feed the
sheet into the printer.
Handle with care! Handle your media carefully to avoid creases,
scrapes, and tears. Avoid crushing or damaging roll media edges.
Wear gloves! Film-based and photographic paper-based media are
very susceptible to scratching and creasing and may absorb skin
oils. Fingerprints on the media prior to printing may result in
visible fingerprints after ink is applied.
Using the correct print mode and printer settings
When printing on photo paper-based or film-based media, use Enhanced
Printing mode. Using other print modes may result in ink pooling,
smears, or banding. Always use an Enhanced Printing mode for images.
Line drawings can be printed in Draft or Normal modes.
If necessary, set the dry time as described in this guide.