ENCAD CADJET 2, Руководство по обслуживанию, Страница: 98 / 369

Troubleshooting
4-12 CADJET 2
The first number shows the currently recorded
maximum PWM (Pulse Width Modulator) value, which
is a value between zero and 255.
The second number refers to the Encoder position
where the error occurred.
(There are 600 Encoder
units per inch.)
The third number is the maximum duration of time (in
milliseconds) that the threshold PWM has been
reached.
Shows the current PWM as last viewed. You can go
into this display while the plotter is running to view the
power being applied to the Servo Motor.
The first
number is a signed value (positive or negative,
depending upon which direction the motor is going).
The second number is the threshold PWM, which is
always 245 in the current firmware version.
The third number tells the current state of the
Carriage: 0 = stopped, 1 = accelerating, 2 = moving
at constant speed, and 4 = decelerating.
The fourth number is the filtered velocity in Encoder
units per millisecond.
A negative number indicates
left to right movement and a positive number
indicates right to left movement.
(If you multiply
Encoder units per millisecond by 1,000 and divide by
600, the result is inches per second.)
The first number shows the current stopped time.
This will usually be zero unless there has been a
failure (Carriage Axis Failure).
The second number is the maximum amount of time
in milliseconds that an error will be allowed to
continue past the time at which the threshold PWM
was reached before the unit shuts down.
The third number is usually at zero unless a function
is being performed (such as cutting the paper) during
which the shutdown criteria are disabled.
MAX PWM/POSITION
14 84 0
PWM/SATURATION
0 245 0 -1
STOP/MAX/DISABLE
0 50 0