ENCAD CADJET 2, Руководство по обслуживанию, Страница: 22 / 369

Table of Contents
xxii CADJET 2
CHAPTER 5 DISASSEMBLY/ASSEMBLY (continued)
Number Title Page
Figure 5.28 Lower Drive Assembly and Stepper Motor Assembly ........................ 5-62
Figure 5.29 Routing of Wires and Cables on Right Side Plate and MPCB ........... 5-68
Figure 5.30 Fixed Blade........................................................................................ 5-70
Figure 5.31 Cutter Assembly ................................................................................ 5-73
Figure 5.32 Upper Roller Support - Normal and Bent for Removal....................... 5-77
Figure 5.33 Removing the Old Upper Roller Support ........................................... 5-78
Figure 5.34 Inserting New Upper Roller Supports ................................................ 5-81
Figure 5.35 Positioning Upper Roller Supports..................................................... 5-82
CHAPTER 6 CALIBRATION
Number Title Page
Figure 6.1 Upper Roller Supports Numbering Sequence...................................... 6-7
Figure 6.2 Inner Stand Off Screws and Turnbuckle ............................................ 6-10
Figure 6.3 Carriage Height Measurement Fixture ............................................... 6-14
Figure 6.4 Installation of Typical Black Cartridge................................................ 6-15
Figure 6.5 Top View of Carriage Board .............................................................. 6-23
Figure 6.6 Upper Roller Support and Mounting Screws...................................... 6-30
Figure 6.7 Correct Positioning of the Spring in the Upper Roller Support........... 6-32
Figure 6.8 Test for Minimum Acceptable Gap .................................................... 6-33
Figure 6.9 Visual Verification of Gap between Roller and Y-Arm ....................... 6-34
Figure 6.10 Paper Skew Acceptance Range for Rear Media Alignment Mark...... 6-36
Figure 6.11 Paper Skew Acceptance Range for Front Media Alignment Mark ..... 6-37
Figure 6.12 Motion of Rollers and Adjustment of Mounting Screws ..................... 6-38
Figure 6.13 Deadband Alignment ......................................................................... 6-47
Figure 6.14 Vertical Lines (All) .............................................................................. 6-51
Figure 6.15 Vertical Lines (One) ........................................................................... 6-52
Figure 6.16 CADJET 2 Calibration Worksheet ..................................................... 6-62