ENCAD CADJET 2, Руководство по обслуживанию, Страница: 295 / 369

Calibration
6-52 CADJET 2
6. Press the UP ARROW. The display will read:
7. Press SELECT. The plotter will draw 16 single 1.5" high vertical
lines one line at a time in uni-directional mode. See
Figure Chapter 6 .15 for a sample.
Figure Chapter 6 .15: Vertical Lines (One)
8. Visually inspect the lines and compare against the printout of the
Line Quality Acceptance Standards files CJ2GS.PLT or
CJ2GSD.PLT (see “Required Documentation and Files” in
Section 3.0 of this chapter). If sub-standard lines at various
regions exist, repeat Steps 1-7 above and change the numbers to
a more acceptable value which will meet the line quality minimum
acceptance criteria for Line Quality and White Space.
9. Continue as needed until the DEADBAND lines in NORMAL mode
are showing a satisfactory deadband calibration. If after
10 minutes and/or a total of 8 trials of various values the minimum
standard cannot be met, stop and call
ENCAD's Technical
Support and Service department. See Chapter 1, Section 3.0.
10. Press MENU 3 times. The display will read:
ONE,F,S(31,0
)
1 (31,0
)
2 3 (31,0
)
6 (31,0
)
5 (31,0
)
4 (31,0
)
CALIBRATION
VERTICAL LINES (ONE)
MAIN MENU
UTILITIES