Emerson EV3200 Скачать руководство пользователя страница 37

Страница: 37 / 63

Chapter 6 Parameter Description 33

EV3200 Door Control Inverter User Manual

the catching torque reaches the setting of F2.10, the relay
will activate to output CD complete signal.

The complete CD signal is disabled in demo mode,
general-purpose inverter operation mode and OD process.

6: Fault relay output 1

When the inverter has fault, the relay will output fault signal.
But when parameter setting error (E028) occurs, the inverter
only displays the alarm information and will not output fault
relay output signal 1.

7: Fault relay output 2

When the inverter has fault or the inverter's DC bus voltage
is low (LED displays "P.oFF"), the relay will output fault
signal. But when parameter setting error (E028) occurs, the
inverter only displays the alarm information and will not
output fault relay output signal 2.

8: Safety edge lift signal output

When width left open in CD is less than or equal to F3.06
setting, the relay outputs safety edge lift signal. When it is
bigger than F3.06 setting, there is no output of safety edge
lift signal.

9: Lock signal output

Synchronously input/output lock signal

10: Door re-opening signal output

In door re-opening process, the relay outputs the door
re-opening signal.

11: Obstruction signal output

When the door is obstructed in OD or CD process, the relay
outputs this signal.

6.7 Motor Parameters F6

F6.00 Motor type selection

Setting range: 0 ~ 1

【

】

0: asynchronous motor

1: synchronous motor

Note

1. For EV3200-2S0002A and EV3200-2S0004A, the default
setting of this parameter is 0.

2. For EV3200-2S0002S and EV3200-2S0004S, the default
setting of this parameter is 1.

F6.01 Motor rated power

Setting range: 0 ~ 500W

【

370

】

F6.02 Motor rated voltage Setting range: 0 ~ 250V

【

220

】

F6.03 Motor rated current Setting range: 0.10 ~ 9.90A

【

1.94

】

F6.04 Motor max
allowable operation current

Setting range: 100.0% ~ 200.0%

【

150%

】

F6.05 Motor rated
frequency

Setting range: 1.00 ~ 128.00Hz

【

50.00

】

F6.06 Motor rated
spinning speed

Setting range: 1 ~ 9999rpm

【

1400

】

Set the motor parameters according to the nameplate.

Note

1. Relevant parameters of motor (F6.01 ~ F6.06) must be input
correctly before auto-tuning.

2. The motor power should match that of the inverter, that is, the
setting of F069 can be only one grade higher or two grades lower
than standard motor capacity, to ensure the performance.

F6.07 Motor tuning

Setting range: 0, 1

【

】

0: disable 1: enable

Enter the motor parameters according to the nameplate
(F6.01 ~ F6.06) before tuning. First set F6.07 to 1, press

on the operation keypad, the inverter will execute
auto-tuning function.

After tuning completed, setting of F6.07 will be restored to 0
automatically.

Note

1. Do not start tuning with load on motor;

2. Make sure the motor is in stopping status before tuning,
otherwise, the tuning can not be processed normally;

3. Tuning can be performed in keypad control mode only
(F0.02=0, factory default value);