ELTEX SMG-1016M, Руководство по эксплуатации

Страница: 342 / 441

342
SMG Digital Gateway
This command enables/disables data flow control mechanism for the interface being configured. Flow control
mechanism allows to compensate the transfer rate difference of the transmitter and receiver. If the traffic
volume exceeds the specific level, the receiver will send frames informing the transmitter on the necessity to
lower the traffic volume and reduce the amount of lost frames. Implementation of this mechanism requires that
the remote device also supports this function.
Syntax
flow-control <act>
Parameters
<act> — assigned action:
–
on — enable
–
off — disable
Default value
off
Example
SMG2016-[CONFIG]-[SWITCH]-[if]> flow-control on
frame-types
The command assigns the specific packet reception rules to the interface:
–
Receive both tagged and untagged packets
–
Receive packets with VLAN tag only
Syntax
frame-types <act>
Parameters
<act> — assigned action:
–
all — receive both tagged and untagged packets
–
tagged — receive packets with VLAN tag only
Default value
All packets are accepted (both tagged and untagged)
Example
SMG2016-[CONFIG]-[SWITCH]-[if]> frame-types all
Untagged traffic reception is enabled for the configured ports.
speed
This command specifies transfer rate value for the configured interface.
Defined modes are as follows: 10Mbps, 100Mbps, 1000Mbps. For 10Mbps or 100Mbps, you should specify the
transceiver operation mode: duplex or half-duplex.
Syntax
speed <rate> [<mode>]