ELTEX SMG-1016M, Руководство по эксплуатации

Страница: 184 / 441

184
SMG Digital Gateway
–
fallback — frame is received on ingress port regardless whether it has 802.1q tag in
'802.1q' routing table or not.

If there is no 802.1q tag in '802.1q' routing table and the frame is allowed in 'output'
section, the frame will be transmitted to the egress port.

Also, the frame will be transmitted to the egress port, if there is 802.1q tag in '802.1q'
routing table, the egress port is a member of VLAN included in '802.1q' routing table
and the frame is allowed in 'output' section.
–
check — the frame will be received on ingress port, if its 802.1q tag is kept in '802.1q'
routing table (the ingress port is not necessary to be a member of VLAN in '802.1q' routing
table)

The frame will be transmitted to an egress port if the egress port is a member of VLAN
in '802.1q' routing table and allowed in 'output' section of the ingress port settings.
–
secure – the frame will be received on ingress port, if its 802.1q tag is kept in '802.1q'
routing table and the ingress port is a member of VLAN in '802.1q' routing table.

The frame will be transmitted to an egress port if the egress port is a member of VLAN
in '802.1q' routing table and allowed in 'output' section of the ingress port settings.

Output — mutual availability of data ports. Defines privileges that allow packets received by this
port to be transferred to flagged ports.

LACP trunk – select LACP group to which the defined port will belong;

Port MAC – change a MAC address of the port. The option is available when LACP group is
selected on the port. Ports which are in the one LACP group should have different MAC addresses.

Reserve port — select the port that will receive the traffic when abnormal situation occurs (i.e.
line interruption). This setting is required for provisioning of Dual Homing redundancy.

Preemption — when checked, return to master port when it becomes available.
This firmware version supports the global dual homing only.

Port mode — select port operation mode (auto, 10/100 Mbps Half, 10/100 Mbps Full, 1 Gbps).
Mode configuration is possible for electric Ethernet ports only ( GE port 0, GE port 1, GE port 2 ).
Click 'Confirm' button in 1 minute interval to confirm settings, or the previous values will be
restored.
To apply settings, click 'Apply' button; to confirm applied settings, click 'Confirm' button.
Click 'Defaults' button to set default parameters. (The figure below shows default values.)
To save settings to the configuration file without applying them, click 'Save' button.
3.1.12.3 802.1q
In '802.1q' submenu, you may define the configuration of packet routing rules for switch operation in
802.1q mode