Elo TouchSystems DOS and Windows Driver Disk, Руководство пользователя

Страница: 117 / 134

114 Appendix Error! Main Document Only.Error! Main Document Only.7 - Error
Messages
ELODEV E
RROR
M
ESSAGES
This section lists the error messages that can be displayed by ELODEV upon
installation, with a brief explanation where necessary. No error messages are ever
output by an installed copy of ELODEV.
ELODEV returns an exit code, sometimes called an "error level" code, that can
allow DOS batch files to process fatal errors with the ERRORLEVEL command.
If the ELODEV command works normally, the returned code is 0; otherwise it's 1.
Cannot output to controller.
A COM port error was detected when trying to set up the controller. You
may have a defective COM port.
COM port not installed.
Self-explanatory.
Controller not detected.
If using the E271-2210 or E271-2200 serial controller, ELODEV did not
detect the DSR RS-232 line from the controller. Make sure your cable
provides the DTR, DSR, RTS, and CTS handshaking lines when using this
controller, or use the -p- flag (see page 32). Also check that the controller
is not in an emulation mode.
If using the E271-2201 PC-Bus controller, ELODEV did not detect the
controller at the Base I/O Port specified. Make sure the jumpered Base I/O
Port matches the ELODEV command line, or try changing both to another
address. Also check that the controller is not in an emulation mode.
If using the E271-2202 Micro Channel controller, make sure you used
your IBM PS/2 Reference Disk to define the adapter to the system.
Controller not found at Base I/O Port address or has incorrect mode switches.
Self-explanatory. Double-check the switches and Base I/O Port jumpers.
Controller not found at Base I/O Port address or is not in 12-bit/Z mode.
For the E281{A}-4025 controller to transmit Z data, its switches must be
set for 12-bit and Z-axis modes.