63/76
MP120
Procedure by means of electronic key
Procedure by means of transponder key
5. Put the key to be programmed into an inserter (if the
key has a code previously stored in the control unit,
the «KEY already mem.» message will appear on
the display. The control unit will randomly generate a
new code and write it into the key; then it will read it
again. If the code matches, it will be validated by the
control unit, and the following message will appear
on the display after approximately 3 seconds:
where “nn” indicates the first free key address. The
system status LED will blink fast.
Move the transponder key near an inserter
transponder: the control unit will recognize that the
code is valid even though it does not match with the
programmed one, and will then store the unique
factory-set key code. The following message will
appear on the display after approximately 3
seconds:
where “nn” indicates the first free key address. The
system status LED will blink fast.
6. Take out the programmed key and repeat the
procedure starting from step 4 if you wish to program
other keys, or press
ESC
several times to exit the
menu.
Repeat the procedure starting from step 4 if you
wish to program other keys, or press
ESC
several
times to exit the menu.
3.11.2 ACQUIRING EXISTING KEYS
One single electronic key (or transponder key) may be used with two separate and compatible systems (e.g. home
and office systems). To allow the control unit to recognize the code of a key previously programmed in another
system, proceed as follows:
1. type in the Master code or the Installer code, then press
ENTER
twice.
2. The following message will appear on the display:
Use button ▼ to select the following menu:
Then press
ENTER
to confirm.
3. The following message will appear on the display:
Use button ▼ to select the following menu:
Then press
ENTER
to confirm.
4. The following message will appear on the display
where
n
indicates the new free location that will be occupied by the key. The system status LED for all the
available inserters will blink slowly.
5. Put the key to be programmed into an inserter (or keep the transponder key near an inserter transponder for 3
seconds). The keyboard buzzer will beep twice to confirm that acquisition has been carried out successfully,
and the system status LED will blink fast.
6. Take out the key and repeat the procedure by starting from step 4 if you wish to acquire other keys, or press
ESC
several times to exit the menu.
Insert KEY n°
n
R e a d K e y C o d e
R e a d N e w K e y
K e y P r o g r a m m i n g
E v e n t M e m o r y
K E Y n n :
K E Y n n :
