40/76
MP120
where “n” indicates the table number, “x” indicates the command number, and “hh:mm” indicate the hour and
minutes set. Press
ENTER
: the first digit of the time will blink. Type in the time (hour and minutes) when the
command is to be performed, then confirm by pressing
ENTER
.
11. Press
ESC
once, then repeat the procedure starting from step 5 for all the other commands to be programmed.
If you do not wish to program other commands, press
ESC
several times to exit the menu.
2.15.3 TABLE ERASING
To erase all the tables, proceed as follows:
1. type in the Installer code (factory setting: 000000), then press
ENTER
twice.
2. The following message will appear on the display:
Press ► until the message below appears:
Then press
ENTER
to confirm.
3. The following message will appear on the display:
Press ▼ until the message below appears:
4. Press
ENTER
to erase: erasing will be confirmed by a double beep. WARNING! The erasing operation is not
reversible.
5. Press
ESC
several time to exit the menu.
2.15.4 CORRELATING THE TABLES TO THE DAYS
To correlate the tables to the various week days, proceed as follows:
1. type in the Installer code (factory setting: 000000), then press
ENTER
twice.
2. The following message will appear on the display:
Press ► until the message below appears:
Then press
ENTER
to confirm.
3. The following message will appear on the display:
Press
ENTER
to confirm: the following message will appear on the display:
where “n” indicates the table correlated to Monday.
4. Use button ▼ to select, if necessary, the day the table correlation of which is to be modified, then press
ENTER
to confirm: the table number will start blinking.
M o n T y p e n
D a y T y p e P r o g .
D a i l y P l a n n e r
E v e n t M e m o r y
'DailyPl. RESET
D a y T y p e P r o g .
D a i l y P l a n n e r
E v e n t M e m o r y
T n C x T i m e : h h : m m
