33/76
MP120
where “xx” indicates when check is carried out, whereas “yy” indicates whether the outputs programmed as
“Tampering” will be actuated in case of failed check (YES - NO).
5. Press
ENTER
: letter “C” will blink. Press
ENTER
again and use button ▼ to select the line check setting, then
confirm the same by pressing
ENTER
.
6. Press ▼: “MAN” will blink on the display. Use button ▼ to choose whether the “Tampering” outputs shall be
actuated (YES) or not (NO), then confirm your choice by pressing
ENTER
.
7. Press
ESC
several times to exit the menu.
2.14.9 VOCAL MESSAGE RECORDING
Vocal telephone messages consist of two parts:
•
the base message, lasting 20 seconds max., which tells you where the event that triggered the alarm is taking
place. Examples of base messages include: “Mr. Roberto Verdi’s house, Piazza Roma 18, Milano”, or “NORKLE
Ltd., Via Pascoli 3, Pavia” (it is recommended that the base message shall be repeated at least twice, to make
sure the address is heard and understood);
•
the event-specific message, which may include, by way of example:
Event
Example of message
Max. time
Break-in
Theft being committed, theft being committed
4 seconds
Tampering
Sabotage, sabotage
4 seconds
Robbery
Robbery being committed, robbery being committed
4 seconds
Panic
Threats of assault
4 seconds
Technological
Technological detector *
4 seconds
Fire
Fire start
4 seconds
Failure
System failure
4 seconds
No mains supply
Electric current missing
4 seconds
Mains supply return Electric current available
4 seconds
Battery low
Control unit battery low
4 seconds
Battery charged
Control unit battery charged
4 seconds
Actuation
Antitheft system actuation
4 seconds
Deactivation
Antitheft system deactivation
4 seconds
Test call
Antitheft system test
4 seconds
* The detectors classified under the technological group may be quite different from one another: if the system
includes only one type of detector, the message can obviously me customized (e.g. “Gas leak” or “Flooding
start”).
Warning! To ensure good recording quality, speak near the microphone.
To record vocal messages, proceed as follows:
1. type in the Installer code (factory setting: 000000), then press
ENTER
twice.
2. The following message will appear on the display:
Press ► until the message below appears:
Then press
ENTER
to confirm.
3. The following message will appear on the display:
Press ▼ until the message below appears:
V o c a l S e t t i n g s
P h o n e N u m b e r P R G
C o m m u n i c a t o r P R G
E v e n t M e m o r y
C : x x M A N : y y