30/76
MP120
Press
ENTER
.
5. The following message will appear on the display:
All the stored telephone numbers will be called (both vocal sending and numeric protocols). To interrupt the call
sequence, press
ESC
. If the message below:
appears after some time, the telephone number configuration will be correct, yet the telephone line will be
broken (or missing).
6. Upon completion of the test, the following message will appear on the display:
Press
ESC
several times to exit the menu.
To interrupt the vocal call reception, type in “12” on the keyboard of the telephone that is receiving the call (it is
required that the telephone will use DTMF tone dialling).
2.14.6 CYCLIC CALL
The cyclic call allows the control unit to automatically call, at regular intervals and for testing purposes, all the
numbers of the programmed remote surveillance centres, to confirm correct operation of the system and of its
telephone connection. The interval between the calls may be set from 1 hour to 7 days, and the count will start from
the synchronism time that has been set. Every telephone call is recorded in the event memory.
Warning!
The actuation of the cyclic call shall be expressly requested by the remote surveillance centre.
To configure a cyclic call, proceed as follows:
1. type in the Installer code (factory setting: 000000), then press
ENTER
twice.
2. The following message will appear on the display:
Press ► until the message below appears:
Then press
ENTER
to confirm.
3. The following message will appear on the display:
Press ▼ until the message below appears:
Then confirm by pressing
ENTER
.
4. The following message will appear on the display:
where “xx” may be:
•
No
, i.e. the cyclic call is disabled;
•
24h
, i.e. the cyclic call is always enabled;
•
OnParz
, i.e. the cyclic call is enabled when the system is ON, even partially;
S e l f T e s t x x
P e r i o d c o m m t e s t
P h o n e N u m b e r P R G
C o m m u n i c a t o r P R G
E v e n t M e m o r y
T e s t C a l l
O F F H O O K
T e s t i n g . . .
